Archive for the 'microcontroller' Category



Wiimote controlled robot

Wednesday 5 September 2007 @ 9:42 am

The Wiimote makes a perfect control system for a fire fighting robot.

It has IR sensors which can detect a candle and a bluetooth transciever to communicate back to a host computer. I use a boebot as the robot platform, an arduino, wiimote and a Linux computer.
The wiimote uses its IR sensor to find the candle. […]




Build 89C51 PABX

Monday 3 September 2007 @ 10:07 pm

Introduction
This project is basically an eight line intercom from which you can call 1 to 8 number. This system also support dialing and receiving telephone calls. ?

Figure 1:?? Block Diagram of the 89C51 PABx
?
How to use

Pick your hand set, the dial tone will be listen now dial 1 to 8 number if the busy tone […]




DIY PIC Oscilloscope

Thursday 30 August 2007 @ 1:03 pm

This is a simple PC voltage oscilloscope using only a PIC12F675, a 20MHz oscillator, and a RS232 level shifter. The PIC takes a sample on GP2, immediately sends it to the PC at 115,200 baud using an software asynchronous serial routine, and repeats. It sends a 8-bit value that is read by the Visual Basic […]




Dot-matrix LED game based on AVR

Sunday 26 August 2007 @ 7:07 pm

This simple game console if we can say so is built under AVR Atmega168. Game display is made of 16




Sine Triangle Square Saw Burst Sweep Noise

Saturday 25 August 2007 @ 9:28 pm

After the recent demise of our multifunction signal generator, we decided to make one of our own.?? The circuit uses a PIC16F870 (about $3), an R/2R resistor ladder network (for a real fast and cheap D/A),? and a few other parts.
You can check out the schematic and the current source file.? Also the object (hex) […]




Page 1 of 8123456»...Last »